Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 144)

144 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Chapter 7 Bulletin 280E/281E/284E Programmable Parameters
Starter Protection Group
Int02DeviceOut Cfg
This parameter is used to specify
Int02DeviceOut of produced assembly
150 or 151.
Parameter Number 15
Access Rule GET/SET
Data Type USINT
Group Produced Assembly Config
Units —
Minimum Value 0
Maximum Value 263
Default Value 5
Int03DeviceOut Cfg
This parameter is used to specify
Int03DeviceOut of produced assembly
150 or 151.
Parameter Number 16
Access Rule GET/SET
Data Type USINT
Group Produced Assembly Config
Units —
Minimum Value 0
Maximum Value 263
Default Value 6
Pr FltResetMode
This parameter is the Protection Fault
reset mode.
0 = Manual
1 = Automatic
Parameter Number 23
Access Rule GET/SET
Data Type BOOL
Group Starter Protection
Units —
Minimum Value 0
Maximum Value 1
Default Value 0