Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 322)

322 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Appendix C Using DeviceLogix
Bulletin 280 and 281 ArmorStart Outputs
The screen capture below shows how to choose outputs in the ladder editor.
The Bulletin 280 and 281 have the following bit definitions:
0 = Run Forward
1 = Run Reverse
2 = User Output A
3 = User Output B
Bulletin 280 and 281 ArmorStart Produced Network Bits
The screen capture below shows how to choose Produced Network Bits in the ladder editor.
The following table contains the produced network bit definitions for Bulletin
280 and 281 ArmorStart units
Produce Network bit declaration
0 = Net Output 0
1 = Net Output 1
2 = Net Output 2
3 = Net Output 3
4 = Net Output 4
5 = Net Output 5
6 = Net Output 6
7 = Net Output 7
8 = Net Output 8
9 = Net Output 9
10 = Net Output 10
11 = Net Output 11
12 = Net Output 12
13 = Net Output 13
14 = Net Output 14
15 = Fault Reset
16 = Motion Disable
17 = Keypad Disable