Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 318)

318 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Appendix C Using DeviceLogix
Download the finished program file to the PLC. In order for the parameters and
DeviceLogix program to update in the device, ensure the PLC is in program
mode, and open the AOP for the Bulletin 284E.
Select the Parameters and DeviceLogic tab. This will force a correlation between
the program file and the device. If a difference exists either upload from the device
or download from the project to the device. In this example you will want to
download.
Figure 104 is an example of the parameter correlation when a difference occurs
between the project and the device.
Figure 104 -
Figure 105 is an example of the DeviceLogix correlation when a difference occurs
between the project and the device.