Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 290)

290 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Appendix B CIP Information
Parameter Object CLASS CODE 0x000F
The following class attributes will be supported for the Parameter Object.
The number of instances of the parameter object will depend upon the type of
Control Module that the EtherNet/IP board is connected to.
The following instance attributes will be implemented for all parameter
attributes.
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT —
2 Get Max Instance UINT —
8 Get Parameter Class Descriptor WORD —
Attribute ID Access Rule Name Data Type Value
1 Get/Set Value Specified in Descriptor —
2 Get Link Path Size USINT —
3 Get Link Path
Array of:
BYTE
EPATH
—
4 Get Descriptor WORD —
5 Get Data Type EPATH —
6 Get Data Size USINT —
7 Get Parameter Name String SHORT_STRING —
8 Get Units String SHORT_STRING —
9 Get Help String SHORT_STRING —
10 Get Minimum Value Specified in Descriptor —
11 Get Maximum Value Specified in Descriptor —
12 Get Default Value Specified in Descriptor —
13 Get Scaling Multiplier UINT —
14 Get Scaling Devisor UINT —
15 Get Scaling Base UINT —
16 Get Scaling Offset INT —
17 Get Multiplier Link UINT —
18 Get Divisor Link UINT —
19 Get Base Link UINT —
20 Get Offset Link UINT —
21 Get Decimal Precision USINT —