Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 74)

74 Rockwell Automation Publication 280E-UM001B-EN-P - July 2012
Chapter 4 Product Commissioning
Using the Rockwell
Automation Embedded
Web Server Internal Web Server
ArmorStart Ethernet/IP internal web server allows you to view information and
configure the ArmorStart via a web browser. The embedded web server is used to
access configuration and status data. Security in the form of an administrative
password can be set. The default Login is Administrator. There is no password
set by default.
To access the internal web browser, open your computers internet browser and
enter the IP address of the desired ArmorStart (for example, 192.168.1.1).
Note: 192.168.1.1 is NOT the factory default IP address as DHCP is enabled
by default.
Figure 57 - Internal Web Browser
From here you are able to view parameter settings, device status, and diagnostics
from multiple tab views.
IMPORTANT Caution: The user should set the password to a unique value for authorized
personnel.
If the login and password are lost you will need to reset the device to the factory
defaults, which results in losing its configuration.