Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 158)

158 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Chapter 7 Bulletin 280E/281E/284E Programmable Parameters
Comm Status
Status of communications ports:
Bit 0 = Receiving Data
Bit 1 = Transmitting Data
Bit 2 = RS485
Bit 3 = Communication Error
Parameter Number 115
Related Parameter 205, 206
Access Rule GET
Data Type UINT
Group Drive Display
Units 1
Minimum Value 0
Maximum Value 1
Default Value Read Only
Control SW Ver
Main Control Board software version
for AC Drive.
Parameter Number 116
Access Rule GET
Data Type UINT
Group Drive Display
Units 0.01
Minimum Value 1.00
Maximum Value 99.99
Default Value Read Only
Drive Type
Used by Rockwell Automation field
service personnel.
Parameter Number 117
Access Rule GET
Data Type UINT
Group Drive Display
Units 1
Minimum Value 1001
Maximum Value 9999
Default Value Read Only
Elapsed Run Time
Accumulated time drive is outputting
power. Time is displayed in 10 hour
increments.
Parameter Number 118
Access Rule GET
Data Type UINT
Group Drive Display
Units 1 = 10 hrs
Minimum Value 0
Maximum Value 9999
Default Value Read Only