Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 83)

Rockwell Automation Publication 280E-UM001B-EN-P - July 2012 83
Adding an ArmorStart to RSLogix 5000 Chapter 5
Offline Connection General Tab
Click on the General tab to display the following:
This tab allows you to name your module, which should be descriptive and
representative of the module. The IP Address of the module must also be input so
that communication can be established. The IP Address should be the one
defined using the BootP/DHCP Server, the Rotary Network Address Switches
or the ArmorStart internal web server.
For the majority of cases, the Host Name and Module Definition section of this
tab do not require any adjustment. Changes to either of these should only be
made if you are familiar with the functionality of each of these sections.