Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 305)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 305
CIP Information Appendix B
Ethernet Link Object CLASS CODE 0x00F6
The following class attributes will be supported.
One instance of the Ethernet Link Object will be supported with the following
instance attributes.
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 3
2 Get Max Instance UINT 2
3 Get Number of Instances UINT 2
Attribute ID Access Rule Name Data Type Value
1 Get Interface Speed UDINT 10 or 100 Mbit/Sec
2 Get Interface Flags DWORD See ENet/IP Spec
3 Get Physical Address ARRAY of 6 USINTs MAC Address
4 Get Interface Counters
Struct of:
In Octets
In Ucast packets
In NUcast packets
In Discards
In Errors
In Unknown Protos
Out Octets
Out Ucast packets
Out NUcast packets
Out Discards
Out Errors
—
5 Get Media Counters
Struct of:
Alignment Errors
FCS Errors
Single Collisions
SQE Test Errors
Deferred Transmits
Late Collisions
Excessive Collisions
MAC Transmit Errors
Carrier Sense Errors
Frame Too Long
MAC Receive Errors
—
6 Get/Set Interface Control
Struct of:
Control Bits
Forced Interface Speed
—
7 Get Interface Type USINT —
8 Get Interface State USINT —
9 Get/Set Admin State USINT —
10 Get Interface Label SHORT_STRING
Instance 1: Port 1
Instance 2: Port 2