Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 321)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 321
Using DeviceLogix Appendix C
The following table contains the status bit definitions for ArmorStart 280D and
281D units:
Bulletin 280 and 281 ArmorStart Fault Bits
The screen capture below shows how to choose fault bits in the ladder editor.
The following table contains the fault bit definitions for Bulletin 280D and
281D ArmorStart units:
Status Bit Declaration
0 = Tripped
1 = Running Fwd
2 = Running Rev
3 = Ready
4 = Net Ctl Status
5 = At Reference
6 = Keypad Hand
7 = HOA Status
8 = 140M On
9 = Explicit Msg Cnxn Exists
10 = IO Cnxn Exists
11 = Explicit Cnxn Fault
12 = IO Cnxn Fault
13 = IO Cnxn Idle
14 = Current Flowing
15 = Keypad Hand Direction
Fault Bit Declaration
0 = Short Circuit
1 = Overload
2 = Phase Loss
3 = Control Power
4 = IO Fault
5 = Over Temp
6 = Phase Imbalance
7 = DNet Power Loss
8 = EEprom
9 = HW Flt
10 = PL Warning
11 = CP Warning
12 = IO Warning
13 = Phase Imbal Warn
14 = DN Warning
15 = HW Warning