Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual User Manual
Page 189
Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
189
Bulletin 280E/281E/284E Programmable Parameters Chapter 7
A
Step if Logic In2 is Active and Logic In1 is Not Active
b
Step after (StpLogic Time x) and Logic In1 is Active
C
Step after (StpLogic Time x) and Logic In2 is Active
d
Step after (StpLogic Time x) and Logic In1 is Not Active
E
Step after (StpLogic Time x) and Logic In2 is Not Active
F
Do Not Stop/Ignore Digit 2 Settings
Table 26 - Digit 2 Settings
0
Jump to Step 0
1
Jump to Step 1
2
Jump to Step 2
3
Jump to Step 3
4
Jump to Step 4
5
Jump to Step 5
6
Jump to Step 6
7
Jump to Step 7
8
End Program (Normal Stop)
9
End Program (Coast to Stop)
A
End Program and Fault (F2)
Table 27 - Digit 3 Settings
Required
Setting
Accel/Decel Parameter
Used
StepLogic
Output State
Commanded Direction
0
Accel/Decel 1
OFF
FWD
1
Accel/Decel 1
OFF
REV
2
Accel/Decel 1
OFF
No Output
3
Accel/Decel 1
ON
FWD
4
Accel/Decel 1
ON
REV
5
Accel/Decel 1
ON
No Output
6
Accel/Decel 2
OFF
FWD
7
Accel/Decel 2
OFF
REV
8
Accel/Decel 2
OFF
No Output
9
Accel/Decel 2
ON
FWD
A
Accel/Decel 2
ON
REV
b
Accel/Decel 2
ON
No Output
Table 25 - Digit 0 and Digit 1 Settings