PLANET WGS3-24240 - Manual (Page 159)

User’s Manual of WGS3-24000 / WGS3-24240
159
4.3.8.1 Spanning Tree Switch Configuration/Status
This page is to enable/disable the Spanning Tree protocol. The switch support IEEE 802.1d Spanning Tree (STP), IEEE 802.1w
Rapid Spanning Tree (RSTP) and IEEE 802.1S Multiple Spanning Tree (MSTP).
Figure 4-3-33 Spanning Tree Switch Configuration/Status
Configurable Data
Object Description
• Spanning Tree Mode Specifies whether spanning tree operation is enabled on the switch.
Value is enabled or disabled
• Force Protocol Version Specifies the Force Protocol Version parameter for the switch.
The options are IEEE 802.1d, IEEE 802.1w and IEEE 802.1s
• Configuration Name Identifier used to identify the configuration currently being used. It may be up to
32 alphanumeric characters
• Configuration Revision
Level
Identifier used to identify the configuration currently being used. The values
allowed are between 0 and 65535.
The default value is 0.
Non-Configurable Data
Object Description
• Configuration digest
key
Identifier used to identify the configuration currently being used.
• MST Table Table consisting of the MST instances (including the CST) and the corresponding
VLAN IDs associated with each of them.
• VID Table Table consisting of the VLAN IDs and the corresponding FID associated with
each of them.
• FID Table Table consisting of the FIDs and the corresponding VLAN IDs associated with
each of them.