PLANET WGS3-24240 - Manual (Page 487)

User’s Manual of WGS3-24000 / WGS3-24240
487
12.4.1 vlan routing
This command creates routing on a VLAN. The <vlanid> value has a range from 1 to 4094.
Format vlan routing <vlanid>
Mode VLAN Config
12.4.1.1 no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4094.
Format no vlan routing <vlanid>
Mode VLAN Config
12.4.2 show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled.
Format show ip vlan
Modes Privileged EXEC
User EXEC
MAC Address used by
Routing VLANs
Is the MAC Address associated with the internal-bridge-router interface (IBRI). The same
MAC Address is used by all VLAN routing interfaces. It will be displayed above the
per-VLAN information.
VLAN ID Is the identifier of the VLAN.
Logical Interface Shows the logical slot/port associated with the VLAN routing interface.
IP Address Displays the IP Address associated with this VLAN.
Subnet Mask Indicates the subnet mask that is associated with this VLAN
12.5 Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router Redundancy Protocol (VRRP) and to view
VRRP status information. VRRP helps provide failover and load balancing when you configure two devices as a VRRP pair.
12.5.1 ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the router. Default none
▫ Format ip vrrp
▫ Mode Global Config
12.5.1.1 no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on the router.