PLANET WGS3-24240 - Manual (Page 550)

User’s Manual of WGS3-24000 / WGS3-24240
550
13.4 Protocol Independent Multicast – Dense Mode (PIM-DM) Commands
This section provides a detailed explanation of the PIM-DM commands. The commands are divided into the following different
groups:
◆ Show commands are used to display device settings, statistics and other information.
◆ Configuration commands are used to configure features and options of the switch. For every configuration command there is
a show command that will display the configuration setting.
13.4.1 ip pimdm
This command enables the administrative mode of PIM-DM in the router.
▫ Default disabled
▫ Format ip pimdm
▫ Mode Global Config
no ip pimdm
This command disables the administrative mode of PIM-DM in the router. IGMP must be enabled before PIM-DM can be
enabled.
▫ Format no ip pimdm
▫ Mode Global Config
13.4.2 ip pimdm mode
This command sets administrative mode of PIM-DM on an interface to enabled.
▫ Default disabled
▫ Format ip pimdm mode <unit/slot/port>
▫ Mode Interface Config
no ip pimdm mode
This command sets administrative mode of PIM-DM on an interface to disabled.
▫ Format no ip pimdm mode <unit/slot/port>
▫ Mode Interface Config
13.4.3 ip pimdm query-interval
This command configures the transmission frequency of hello messages between PIM enabled neighbors. This field has a
range of 10 to 3600 seconds.
▫ Default 30
▫ Format ip pimdm query-interval <seconds>
▫ Mode Interface Config