PLANET WGS3-24240 - Manual (Page 473)

User’s Manual of WGS3-24000 / WGS3-24240
473
▫ Mode Global Config
12.1.14 arp timeout
This command configures the ARP entry ageout time.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry ageout time in seconds. The range for
<seconds> is between 15-21600 seconds.
▫ Default 1200
▫ Format arp timeout <15-21600>
▫ Mode Global Config
12.1.15 no arp timeout
This command configures the default ARP entry ageout time.
▫ Format no arp timeout
▫ Mode Global Config
12.1.16 clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the gateway keyword is specified,
the dynamic entries of type gateway are purged as well.
▫ Format clear arp-cache [gateway]
▫ Mode Privileged EXEC
12.1.17 show arp
This command displays the Address Resolution Protocol (ARP) cache. The displayed results are not the total ARP entries. To
view the total ARP entries, the operator should view the show arp results in conjunction with the show arp switch results.
▫ Format show arp
▫ Mode Privileged EXEC
Age Time (seconds) Is the time it takes for an ARP entry to age out. This value was configured into the unit.
Age time is measured in seconds.
Response Time (seconds) Is the time it takes for an ARP request timeout. This value was configured into the unit.
Response time is measured in seconds.
Retries Is the maximum number of times an ARP request is retried. This value was configured into
the unit.