PLANET WGS3-24240 - Manual (Page 46)

User’s Manual of WGS3-24000 / WGS3-24240
46
4.2.3.3 Network Connectivity
The network interface is the logical interface used for in-band connectivity with the WGS3 Layer 3 Switch via any of its front
panel ports. The configuration parameters associated with the switch's network interface do not affect the configuration of the
front panel ports through which traffic is switched or routed.
Figure 4-2-5 Network Connectivity Configuration
To access the WGS3 Layer 3 Switch over a network you must first configure it with IP information (IP address, subnet mask,
and default gateway). You can configure the IP information using any of the following:
。 BOOTP
。 DHCP
。 Terminal interface via the EIA-232 port
Once you have established in-band connectivity, you can change the IP information using any of the following:
。 Terminal interface via the EIA-232 port
。 Terminal interface via telnet
。 SNMP-based management
。 Web-based management
The page includes the following configurable data:
Object Description
• IP Address The IP address of the interface.
The factory default value is 192.168.1.254
• Subnet Mask The IP subnet mask for the interface.
The factory default value is 255.255.255.0