PLANET WGS3-24240 - Manual (Page 510)

User’s Manual of WGS3-24000 / WGS3-24240
510
Area ID The area ID of the area from which this route is learned.
Next Hop Next hop toward the destination
Next Hop Intf The outgoing router interface to use when forwarding traffic to the next hop.
12.7.43 show ip ospf area
This command displays information about the area. The <areaid> identifies the OSPF area that is being displayed.
▫ Format show ip ospf area <areaid>
▫ Modes Privileged EXEC
User EXEC
AreaID Is the area id of the requested OSPF area
External Routing Is a number representing the external routing capabilities for this area.
Spf Runs Is the number of times that the intra-area route table has been calculated using this area's
link-state database
Area Border Router Count The total number of area border routers reachable within this area.
Area LSA Count Total number of link-state advertisements in this area's link-state database, excluding AS
External LSA's.
Area LSA Checksum A number representing the Area LSA Checksum for the specified AreaID excluding the
external (LS type 5) link-state advertisements.
Import Summary LSAs Shows whether to import summary LSAs.
OSPF Stub Metric Value Shows the metric value of the stub area. This field displays only if the area is a
configured as a stub area.
The following OSPF NSSA specific information displays only if the area is configured as an NSSA.
Import Summary LSAs Shows whether to import summary LSAs into the NSSA.
Redistribute into NSSA Shows whether to redistribute information into the NSSA
Default Information
Originate
Shows whether to advertise a default route into the NSSA
Default Metric Shows the metric value for the default route advertised into the NSSA.
Default Metric Type Shows the metric type for the default route advertised into the NSSA.