PLANET WGS3-24240 - Manual (Page 380)

User’s Manual of WGS3-24000 / WGS3-24240
380
▫ Default 5
▫ Format serial timeout <0 - 160>
▫ Mode Line Config
8.5.11.1 no serial timeout
This command sets the maximum connect time (in minutes) without console activity to 5.
▫ Format no serial timeout
▫ Mode Line Config
8.5.12 set prompt
This command changes the name of the prompt. The length of name may be up to 64 alphanumeric characters.
▫ Format set prompt <prompt string>
▫ Mode Privileged EXEC
8.5.13 show forwardingdb agetime
This command displays the timeout for address aging. In an IVL system, the [fdbid | all] parameter is required.
▫ Default all
▫ Format show forwardingdb agetime [fdbid | all]
▫ Mode Privileged EXEC
Forwarding DB ID Fdbid (Forwarding database ID) indicates the forwarding database whose aging timeout is to be shown.
The all option is used to display the aging timeouts associated with all forwarding databases. This field displays the forwarding
database ID in an IVL system.
Agetime Displays the address aging timeout for the associated forwarding database in IVL.
8.7.14 show network
This command displays configuration settings associated with the switch's network interface. The network interface is the
logical interface used for in-band connectivity with the switch via any of the switch's front panel ports. The configuration
parameters associated with the switch's network interface do not affect the configuration of the front panel ports through which
traffic is switched or routed.
▫ Format show network
▫ Mode Privileged EXEC and User EXEC
▫ IP Address - The IP address of the interface. The factory default value is 0.0.0.0
▫ Subnet Mask - The IP subnet mask for this interface. The factory default value is 0.0.0.0
▫ Default Gateway - The default gateway for this IP interface. The factory default value is 0.0.0.0
▫ Burned In MAC Address - The burned in MAC address used for in-band connectivity.
▫ Locally Administered MAC Address - If desired, a locally administered MAC address can be configured for in-band
connectivity. To take effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the address as twelve
hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0
should have the following mask 'xxxx xx10'. The MAC address used by this bridge when it must be referred to in a unique
fashion. It is recommended that this be the numerically smallest MAC address of all ports that belong to this bridge.