PLANET WGS3-24240 - Manual (Page 378)

User’s Manual of WGS3-24000 / WGS3-24240
378
▫ The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
▫ Format network mac-address <macaddr>
▫ Mode Privileged EXEC
8.5.5 network mac-type
This command specifies whether the burned in MAC address or the locally-administered MAC address is used.
▫ Default burnedin
▫ Format network mac-type {local | burnedin}
▫ Mode Privileged EXEC
8.5.5.1 no network mac-type
This command resets the value of MAC address to its default.
Format no network mac-type
Mode Privileged EXEC
8.5.6 network parms
This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the gateway must be on the
same subnet.
Format network parms <ipaddr> <netmask> [<gateway>]
Mode Privileged EXEC
8.5.7 network protocol
This command specifies the network configuration protocol to be used. If you modify this value change is effective immediately.
Default None
Format network protocol {none | bootp | dhcp}, where bootp indicates that the switch periodically sends requests to a
Bootstrap Protocol (BootP) server or a dhcp server until a response is received. none indicates that the switch should be
manually configured with IP information.
Mode Privileged EXEC
8.5.8 remotecon maxsessions
This command specifies the maximum number of remote connection sessions that can be established. A value of 0 indicates
that no remote connection can be established. The range is 0 to 5.
Default 5
Format remotecon maxsessions <0-5>
Mode Privileged EXEC
8.5.8.1 no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to the default value.
▫ Default 5