PLANET WGS3-24240 - Manual (Page 258)

User’s Manual of WGS3-24000 / WGS3-24240
258
4.6.4.1 OSPF Configuration
Figure 4-6-15 OSPF Configuration
Configurable Data
Object Description
• Router ID The 32 bit integer in dotted decimal format that uniquely identifies the router
within the autonomous system (AS). If you want to change the Router ID you
must first disable OSPF. After you set the new Router ID, you must re-enable
OSPF to have the change take effect. The default value is 0.0.0.0, although this
is not a valid Router ID.
• OSPF Admin Mode* Select enable or disable from the pulldown menu. If you select enable OSPF will
be activated for the switch. The default value is disable. You must configure a
Router ID before OSPF can become operational. You do this on the IP
Configuration page or by issuing the CLI command: config router id.
Once OSPF is initialized on the router, it will remain initialized until the router is reset.
。 RFC 1583 Compatibility - Select enable or disable from the pulldown menu to specify the preference rules that will
be used when choosing among multiple AS-external-LSAs advertising the same destination. If you select enable,
the preference rules will be those defined by RFC 1583. If you select disable, the preference rules will be those