PLANET WGS3-24240 - Manual (Page 509)

User’s Manual of WGS3-24000 / WGS3-24240
509
External LSDB Limit Shows the maximum number of non-default AS-external-LSAs entries that can be stored
in the link-state database.
Default Metric Default value for redistributed routes.
Default Route Advertise Indicates whether the default routes received from other source protocols are advertised
or not
Always Shows whether default routes are always advertised.
Metric Shows the metric for the advertised default routes. If the metric is not configured, this field
is blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Maximum Paths Shows the maximum number of paths that OSPF can report for a given destination.
Redistributing This field is a heading and appears only if you configure the system to take routes learned
from a non-OSPF source and advertise them to its peers.
Source Shows source protocol/routes that are being redistributed. Possible values are static,
connected, BGP, or RIP.
Metric Shows the metric of the routes being redistributed.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Tag Shows the decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the specified protocol.
Distribute-List Shows the access list used to filter redistributed routes.
12.7.42 show ip ospf abr
This command displays the internal OSPF routing table entries to Area Border Routers (ABR). This command takes no options.
▫ Format show ip ospf abr
▫ Modes Privileged EXEC
User EXEC
Type The type of the route to the destination. It can be either:
▫ intra — Intra-area route
▫ inter — Inter-area route
Router ID Router ID of the destination
Cost Cost of using this route