PLANET WGS3-24240 - Manual (Page 458)

User’s Manual of WGS3-24000 / WGS3-24240
458
10.2.2 ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1), SSH2 (2), or both SSH 1 and
SSH 2 (1 and 2) can be set.
▫ Default 1 and 2
▫ Format ip ssh protocol [1] [2]
▫ Mode Privileged EXEC
10.2.3 show ip ssh
This command displays the ssh settings.
▫ Format show ip ssh
▫ Mode Privileged EXEC
▫ Administrative Mode - This field indicates whether the administrative mode of SSH is enabled or disabled.
▫ Protocol Level - The protocol level may have the values of version 1, version 2 or both versions 1 and version 2.
▫ Connections - This field specifies the current ssh connections.
10.3 HTTP Commands
The commands in this section is not supported currently
10.3.1 ip http secure-port
This command is used to set the sslt port where port can be 1-65535 and the default is port 443.
▫ Default 443
▫ Format ip http secure-port <portid>
▫ Mode Privileged EXEC
10.3.1.1 no ip http secure-port
This command is used to reset the sslt port to the default value.
▫ Format no ip http secure-port
▫ Mode Privileged EXEC
10.3.2 ip http secure-protocol
This command is used to set protocol levels (versions). The protocol level can be set to TLS1, SSL3 or to both TLS1 and SSL3.
▫ Default SSL3 and TLS1
▫ Format ip http secure-protocol [SSL3] [TLS1]
▫ Mode Privileged EXEC
10.3.2.1 no ip http secure-protocol
This command is used to remove protocol levels (versions) for secure HTTP.
▫ Format no ip http secure-protocol [SSL3] [TLS1]
▫ Mode Privileged EXEC