PLANET WGS3-24240 - Manual (Page 501)

User’s Manual of WGS3-24000 / WGS3-24240
501
<neighbor>. The <neighbor> parameter is the Router ID of the neighbor. The range for seconds is 0 to 3600.
▫ Default 5
▫ Format area <areaid> virtual-link <neighbor> retransmit-interval <seconds>
▫ Mode Router OSPF Config
no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface on the virtual interface identified by
<areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
▫ Format no area <areaid> virtual-link <neighbor> retransmit-interval
▫ Mode Router OSPF Config
12.7.20 area virtual-link transmit-delay (OSPF)
This command configures the transmit delay for the OSPF virtual interface on the virtual interface identified by <areaid> and
<neighbor>. The <neighbor> parameter is the Router ID of the neighbor. The range for seconds is 0 to 3600 (1 hour).
▫ Default 1
▫ Format area <areaid> virtual-link <neighbor> transmit-delay <seconds>
▫ Mode Router OSPF Config
no area virtual-link transmit-delay
This command resets the default transmit delay for the OSPF virtual interface to the default value.
▫ Format no area <areaid> virtual-link <neighbor> transmit-delay
▫ Mode Router OSPF Config
12.7.21 default-information originate (OSPF)
This command is used to control the advertisement of default routes.
▫ Default metric—unspecified type—2
▫ Format default-information originate [always] [metric <0-16777214>] [metric-type {1 | 2}]
▫ Mode Router OSPF Config
no default-information originate (OSPF)
This command is used to control the advertisement of default routes.
▫ Format no default-information originate [metric] [metric-type]
▫ Mode Router OSPF Config
12.7.22 default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.