PLANET WGS3-24240 - Manual (Page 336)

User’s Manual of WGS3-24000 / WGS3-24240
336
4.7.4.4 Mstat Show
This screen is used to display the results of an mstat command.
Figure 4-6-71 Mstat Show
Non-Configurable Data
o This screen shows the path taken by multicast traffic between the specified IP addresses. Forward data flow is
indicated by arrows pointing downward and the query path is indicated by arrows pointing upward. For each hop,
both the entry and exit addresses of the router are shown if different, along with the initial TTL required for packets to
be forwarded at this hop and the propagation delay across the hop. The right half of the screen displays statistics for
the path in two groups. Within each group, the columns are the number of packets lost, the number of packets sent,
the percentage lost, and the average packet rate at each hop. These statistics are calculated from differences
between traces and from hop to hop. The first group shows the statistics for all traffic flowing out the interface at one
hop and in the interface at the next hop. The second group shows the statistics only for traffic forwarded from the
specified source to the specified group.
Command Buttons
o New Mstat - Redirect the web browser to the Mstat Run screen so that you can initiate another mstat command.
o Refresh - Refresh the content of the screen with the latest data available on the router. Typically, it takes around 20
seconds to process the results after initiating mstat command. You must refresh the screen to display the latest
results.