PLANET WGS3-24240 - Manual (Page 525)

User’s Manual of WGS3-24000 / WGS3-24240
525
▫ Format split-horizon {none | simple | poison}
▫ Mode Router RIP Config
no split-horizon
This command sets the default RIP split horizon mode.
▫ Format no split-horizon
▫ Mode Router RIP Config
12.8.14 redistribute (RIP)
This command configures RIP protocol to redistribute routes from the specified source protocol/routers. There are five possible
match options. When you submit the command redistribute ospf match <match-type> the match-type or types specified are
added to any match types presently being redistributed. Internal routes are redistributed by default.
▫ Default metric—not-configured
match—internal
▫ Format for OSPF as source protocol
redistribute ospf [metric <0-15>] [match [internal] [external 1] [external 2] [nssa-external 1]
[nssa-external-2]]
▫ Format for other source protocol
redistribute {bgp | static | connected} [metric <0-15>]
▫ Mode Router RIP Config
no redistribute
This command de-configures RIP protocol to redistribute routes from the specified source protocol/routers.
▫ Format no redistribute {ospf | bgp | static | connected} [metric] [match [internal] [external 1] [external 2]
[nssa-external 1] [nssa-external-2]]
▫ Mode Router RIP Config
12.8.15 show ip rip
This command displays information relevant to the RIP router.
▫ Format show ip rip
▫ Modes Privileged EXEC
User EXEC
RIP Admin Mode Enable or disable.
Split Horizon Mode None, simple or poison reverse.
Auto Summary Mode Enable or disable. If enabled, groups of adjacent routes are summarized into single
entries, in order to reduce the total number of entries The default is enable.