PLANET WGS3-24240 - Manual (Page 358)

User’s Manual of WGS3-24000 / WGS3-24240
358
Quick Start up Uploading from Switch to Out-of-Band PC (Only XMODEM)
Command Details
copy {
nvram:startup-config |
nvram:errorlog |
nvram:msglog |
nvram:traplog} <url>
The types are:
▫ config - configuration file
▫ errorlog - error log
▫ system trace - system trace
▫ traplog - trap log
The URL must be specified as:
▫ xmodem:filepath/fileName
This starts the upload and also displays the mode of uploading and the
type of upload it is and confirms the upload is taking place.
For example:
If the user is using HyperTerminal, the user must specify where the file is
going to be received by the PC.
Table 5-4 Quick Start up Uploading from Switch to Out-of-Band PC (XMODEM)
Quick Start up Downloading from Out-of-Band PC to Switch (Only XMODEM)
Command Details
copy <url>
{nvram:startup-config |
system: image}
Sets the destination (download) data type to be an image (system:image)
or a configuration file (nvram:startup-config).
The URL must be specified as:
xmodem:filepath/fileName
For example:
If the user is using HyperTerminal, the user must specify which file is to be
sent to the switch.
The Switch will restart automatically once the code has been downloaded.
Table 5-5 Quick Start up Downloading from Out-of-Band PC to Switch (Only XMODEM)
Quick Start up Downloading from TFTP Server
Before starting a TFTP server download, the operator must complete the Quick Start up for the IP Address.
Command Details
copy <url>
{nvram:startup-config |
system: image}
Sets the destination (download) data type to be an image (system:image)
or a configuration file (nvram:startup-config).
The URL must be specified as:
tftp://ipAddr/filepath/fileName.
The nvram:startup-config option downloads the configuration file using tftp
and system:image option downloads the code file.
Table 5-6 Quick Start up Downloading from TFTP Server