PLANET WGS3-24240 - Manual (Page 471)

User’s Manual of WGS3-24000 / WGS3-24240
471
▫ Mode Global Config
12.1.3 ip proxy-arp
This command enables proxy ARP on a router interface. Without proxy ARP, a device only responds to an ARP request if the
target IP address is an address configured on the interface where the ARP request arrived. With proxy ARP, the device may
also respond if the target IP address is reachable. The device only responds if all next hops in its route to the destination are
through interfaces other than the interface that received the ARP request.
▫ Default enabled
▫ Format ip proxy-arp
▫ Mode Interface Config
12.1.4 no ip proxy-arp
This command disables proxy ARP on a router interface.
▫ Format no ip proxy-arp
▫ Mode Interface Config
12.1.5 arp cachesize
This command configures the ARP cache size. The ARP cache size value is a platform specific integer value. The default size
also varies depending on the platform.
▫ Format arp cachesize <platform specific integer value>
▫ Mode Global Config
12.1.6 no arp cachesize
This command configures the default ARP cache size.
▫ Format no arp cachesize
▫ Mode Global Config
12.1.7 arp dynamicrenew
This command enables the ARP component to automatically renew dynamic ARP entries when they age out.
▫ Default enable
▫ Format arp dynamicrenew
▫ Mode Priviledge EXEC