PLANET WGS3-24240 - Manual (Page 521)

User’s Manual of WGS3-24000 / WGS3-24240
521
12.8 Routing Information Protocol (RIP) Commands
This section describes the commands you use to view and configure RIP, which is a distance-vector routing protocol that you
use to route traffic within a small network.
12.8.1 router rip
Use this command to enter Router RIP mode.
▫ Format router rip
▫ Mode Global Config
12.8.2 enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
▫ Default enabled
▫ Format enable
▫ Mode Router RIP Config
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
▫ Format no enable
▫ Mode Router RIP Config
12.8.3 ip rip
This command enables RIP on a router interface.
▫ Default disabled
▫ Format ip rip
▫ Mode Interface Config
no ip rip
This command disables RIP on a router interface.
▫ Format no ip rip
▫ Mode Interface Config
12.8.4 auto-summary
This command enables the RIP auto-summarization mode.