PLANET WGS3-24240 - Manual (Page 536)

User’s Manual of WGS3-24000 / WGS3-24240
536
13.2 Distance Vector Multicast Routing Protocol (DVMRP) Commands
This section provides a detailed explanation of the DVMRP commands. The commands are divided into the following different
groups:
◆Show commands are used to display device settings, statistics and other information.
◆Configuration commands are used to configure features and options of the switch. For every configuration command there is
a show command that will display the configuration setting.
13.2.1 ip dvmrp
This command sets administrative mode of DVMRP in the router to active. IGMP must be enabled before DVMRP can be
enabled.
▫ Default disabled
▫ Format ip dvmrp
▫ Mode Global Config
no ip dvmrp
This command sets administrative mode of DVMRP in the router to inactive. IGMP must be enabled before DVMRP can be
enabled.
▫ Format no ip dvmrp
▫ Mode Global Config
13.2.2 ip dvmrp metric
This command configures the metric for an interface. This value is used in the DVMRP messages as the cost to reach this
network. This field has a range of 1 to 63.
▫ Default 1
▫ Format ip dvmrp metric <metric>
▫ Mode Interface Config
no ip dvmrp metric
This command resets the metric for an interface to the default value. This value is used in the DVMRP messages as the cost to
reach this network.
▫ Format no ip dvmrp metric
▫ Mode Interface Config
13.2.3 ip dvmrp trapflags
This command enables the DVMRP trap mode.
▫ Default disabled