PLANET WGS3-24240 - Manual (Page 504)

User’s Manual of WGS3-24000 / WGS3-24240
504
12.7.28 ip ospf authentication
This command sets the OSPF Authentication Type and Key for the specified interface. The value of <type> is either none,
simple or encrypt. The [key] is composed of standard displayable, non-control keystrokes from a Standard 101/102-key
keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the type is encrypt, the key may
be up to 16 bytes. If the type is encrypt a <keyid> in the range of 0 and 255 must be specified. Unauthenticated interfaces do not
need an authentication key or authentication key ID.
▫ Default none
▫ Format ip ospf authentication {none | {simple <key>} | {encrypt <key> <keyid>}}
▫ Mode Interface Config
no ip ospf authentication
This command sets the default OSPF Authentication Type for the specified interface.
▫ Format no ip ospf authentication
▫ Mode Interface Config
12.7.29 ip ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1 to 65535.
▫ Default 10
▫ Format ip ospf cost <1-65535>
▫ Mode Interface Config
no ip ospf cost
This command configures the default cost on an OSPF interface.
▫ Format no ip ospf cost
▫ Mode Interface Config
12.7.30 ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface. The value for <seconds> is a valid positive integer, which
represents the length of time in seconds that a router's Hello packets have not been seen before its neighbor routers declare
that the router is down. The value for the length of time must be the same for all routers attached to a common network. This
value should be some multiple of the Hello Interval (i.e. 4). Valid values range for seconds is from 1 to 2147483647.
▫ Default 40
▫ Format ip ospf dead-interval <seconds>
▫ Mode Interface Config
no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
▫ Format no ip ospf dead-interval