PLANET WGS3-24240 User Manual
Page 293
User’s Manual of WGS3-24000 / WGS3-24240
293
。
Remove IP Address - This appears only if the user selects Specific Dynamic/Gateway Entry or Specific Static Entry
in the Remove from Table Drop Down List. Allows the user to enter the IP Address against the entry that is to be
removed from the ARP Table.
Non-Configurable Data
。
Cache Size - Maximum number of ARP cache entries allowed. This is the cumulative number we get after adding
the Maximum ARP entries for each interface
。
Total Entry Count - Total number of Entries in the ARP table.
。
Peak Total Entries - Highest value reached by Total Entry Count. This counter value is restarted whenever the ARP
table Cache Size value is changed.
。
Active Static Entries - Total number of Active Static Entries in the ARP table.
。
Configured Static Entries - Total number of Configured Static Entries in the ARP table.
。
Maximum Static Entries - Maximum number of Static Entries that can be defined.
。
IP Address - The IP address of a device on a subnet attached to one of the switch's routing interfaces.
。
MAC Address - The unicast MAC address for the device. The format is six two-digit hexadecimal numbers
separated by colons, for example 00:06:29:32:81:40.
。
Slot/Port - The routing interface associated with the ARP entry.
。
Type - The type of the ARP entry:
Local - An ARP entry associated with one of the switch's routing interface's MAC addresses
Gateway - A dynamic ARP entry whose IP address is that of a router
Static - An ARP entry configured by the user
Dynamic - An ARP entry which has been learned by the router
。
Age - Age since the entry was last refreshed in the ARP Table. The format is hh:mm:ss.