PLANET WGS3-24240 - Manual (Page 486)

User’s Manual of WGS3-24000 / WGS3-24240
486
12.3.6 ip irdp preference
This command configures the preferability of the address as a default router address, relative to other router addresses on the
same subnet.
▫ Default 0
▫ Format ip irdp preference <-2147483648 to 2147483647>
▫ Mode Interface Config
12.3.6.1 no ip irdp preference
This command configures the default preferability of the address as a default router address, relative to other router addresses
on the same subnet.
▫ Format no ip irdp preference
▫ Mode Interface Config
12.3.7 show ip irdp
This command displays the router discovery information for all interfaces, or a specified interface.
▫ Format show ip irdp {<slot/port> | all}
▫ Modes Privileged EXEC
User EXEC
Interface Shows the <slot/port> that matches the rest of the information in the row.
Ad Mode Displays the advertise mode, which indicates whether router discovery is
enabled or disabled on this interface.
Advertise Address Displays the IP address to which the interface sends the advertisement.
Max Int Displays the maximum advertise interval, which is the maximum time, in sec
onds, allowed between sending router advertisements from the interface.
Min Int Displays the minimum advertise interval, which is the minimum time, in seconds, allowed
between sending router advertisements from the interface.
Hold Time Displays the amount of time, in seconds, that a system should keep the router
advertisement before discarding it.
Preference Displays the preference of the address as a default router address, relative to other router
addresses on the same subnet.
12.4 Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to view VLAN routing status information.