PLANET WGS3-24240 - Manual (Page 542)

User’s Manual of WGS3-24000 / WGS3-24240
542
no set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time on the system to 0. A value of 0 indicates an infinite timeout, i.e.
no expiration.
▫ Format no set igmp mcrtrexpiretime
▫ Mode Global Config
13.3.4 ip igmp last-member-query-count
This command sets the number of Group-Specific Queries sent before the router assumes that there are no local members on
the interface. The range for <count> is 1 to 20.
▫ Format ip igmp last-member-query-count <count>
▫ Mode Interface Config
no ip igmp last-member-query-count
This command resets the number of Group-Specific Queries to the default value.
▫ Format no ip igmp last-member-query-count
▫ Mode Interface Config
13.3.5 igmp last-member-query-interval
This command configures the Maximum Response Time being inserted into Group-Specific Queries sent in response to Leave
Group messages on the interface. The range for <seconds> is 0 to 255 tenths of a second.
▫ Default 10 tenths of a second (1 second)
▫ Format ip igmp last-member-query-interval <seconds>
▫ Mode Interface Config
no ip igmp last-member-query-interval
This command resets the Maximum Response Time being inserted into Group-Specific Queries sent in response to Leave
Group messages on the interface to the default value.
▫ Format no ip igmp last-member-query-interval
▫ Mode Interface Config
13.3.6 ip igmp query-interval
This command configures the query interval for the specified interface. This is the frequency at which IGMP Host-Query packets
are transmitted on this interface. The range for <queryinterval> is 1 to 3600 seconds.
▫ Default 125 seconds
▫ Format ip igmp query-interval <seconds>
▫ Mode Interface Config