PLANET WGS3-24240 - Manual (Page 409)

User’s Manual of WGS3-24000 / WGS3-24240
409
Note: This command is valid only when the Link Up/Down Flag is enabled (see "snmpserver enable traps linkmode").
▫ Format snmp trap link-status all
▫ Mode Global Config
8.6.56.1 no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see "snmpserver enable traps linkmode").
▫ Format no snmp trap link-status all
▫ Mode Global Config
8.6.57 spanning-tree
This command sets the STP mode for a specific port-channel (LAG). This is the value specified for STP Mode on the Port
Configuration Menu. 802.1D mode is the default. The interface is a logical slot and port for a configured port-channel. The all
option sets all configured port-channels (LAGs) with the same option.
▫ Format spanning-tree {<logical slot/port> | all} {off | 802.1d | fast}
▫ ModeGlobal Config
The mode is one of the following:
802.1d IEEE 802.1D-compliant STP mode is used
fast Fast STP mode is used
off STP is turned off
8.6.58 spanning-tree bpdumigrationcheck
This command enables BPDU migration check on a given interface. The all option enables BPDU migration check on all
interfaces.
▫ Format spanning-tree bpdumigrationcheck {<slot/port> | all}
▫ Mode Global Config
8.6.58.1 no spanning-tree bpdumigrationcheck
This command disables BPDU migration check on a given interface. The all option disables BPDU migration check on all
interfaces.
▫ Format no spanning-tree bpdumigrationcheck {<slot/port> | all}
▫ Mode Global Config
8.6.59 description
This command sets the description information for the interface. The description is an alphanumeric string of up to 64
characters. To use spaces as part of a description, enclose it in double quotes like: "Port 1 connect to Ln 1"
▫ Format description <description>