11 dhcp server – PLANET WGS3-24240 User Manual

Page 95

Advertising
background image

User’s Manual of WGS3-24000 / WGS3-24240

95

4.2.11 DHCP Server

The Dynamic Host Configuration Protocol (DHCP) Server gives out IP addresses when a device is booting up and request an IP

to logged on to the network. It must be set as a DHCP client to obtain the IP address sutomatically.

4.2.11.1 Global Configuration

Figure 4-2-50 DHCP Server Global Configuration

Configurable Data

Object

Description

• Admin Mode

Specifies if the DHCP Service is to be Enabled or Disabled.

Default value is Disable.

• Ping Packet Count

Specifies the number of packets a server sends to a Pool address to check for

duplication as part of a ping operation.

Default value is 2. Valid Range is (0, 2 to 10).

Setting the value to 0 will disable the function.

• Conflict Logging Mode Specifies if conflict logging on a DHCP Server is to be Enabled or Disabled.

Default value is Enable.

• Bootp Automatic Mode Specifies if Bootp for dynamic pools is to be Enabled or Disabled.

Default value is Disable.

• Add Excluded

Addresses

Specifies the IP addresses that the server should not assign to the client.

• From - Specifies the low address in case the user wants to exclude a range of

addresses. Specifies the address to be Excluded in case the user wants to

exclude a single address.

Advertising
This manual is related to the following products: