PLANET WGS3-24240 - Manual (Page 76)

User’s Manual of WGS3-24000 / WGS3-24240
76
4.2.7.2 Trap Receiver Configuration
Trap Manager specifies the Network Management Stations (NMS) that will receive trap messages from the SNMP agent and
can up to 5 entries. This menu will display an entry for every active Trap Receiver.
Figure 4-2-34 SNMP Trap Receiver
Configurable Data
Object Description
• SNMP Community
Name
Enter the community string for the SNMP trap packet to be sent to the trap
manager. This may be up to 16 characters and is case sensitive.
• IP Address Enter the IP address to receive SNMP traps from this device. Enter 4 numbers
between 0 and 255 separated by periods.
• Status Select the receiver's status from the pulldown menu:
• Enable send traps to the receiver
• Disable Do not send traps to the receiver.
4.2.7.3 Supported MIBS
This is a list of all the MIBs supported by the switch.
。 Name - The RFC number if applicable and the name of the MIB.
。 Description - The RFC title or MIB description.
。 Refresh - Update the data.