PLANET WGS3-24240 - Manual (Page 508)

User’s Manual of WGS3-24000 / WGS3-24240
508
▫ Mode Router OSPF Config
no trapflags
This command disables OSPF traps.
▫ Format no trapflags
▫ Mode Router OSPF Config
12.7.41 show ip ospf
This command displays information relevant to the OSPF router.
▫ Format show ip ospf
▫ Mode Privileged EXEC
NOTE: Some of the information below displays only if you enable OSPF and configure certain features.
Router ID A 32-bit integer in dotted decimal format identifying the router, about which information is
displayed. This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This
is a configured value.
ASBR Mode Reflects whether the ASBR mode is enabled or disabled. Enable implies that the router is
an autonomous system border router. Router automatically becomes an ASBR when it is
configured to redistribute routes learnt from other protocol. The possible values for the
ASBR status is enabled (if the router is configured to re-distribute routes learnt by other
protocols) or disabled (if the router is not configured for the same).
RFC 1583 Compatibility Reflects whether 1583 compatibility is enabled or disabled. This is a configured value.
ABR Status Shows whether the router is an OSPF Area Border Router.
Exit Overflow Interval Shows the number of seconds that, after entering OverflowState, a router will attempt to
leave OverflowState.
External LSA Count Shows the number of external (LS type 5) link-state advertisements in the link-state
database.
External LSA Checksum Shows the sum of the LS checksums of external link-state advertisements contained in the
link-state database.
New LSAs Originated Shows the number of new link-state advertisements that have been originated.
LSAs Received Shows the number of link-state advertisements received determined to be new
instantiations.