PLANET WGS3-24240 - Manual (Page 530)

User’s Manual of WGS3-24000 / WGS3-24240
530
▫ Default none
▫ Format mrinfo [<ipaddr>]
▫ Mode Privileged EXEC
13.1.6 mstat
This command is used to find the IP Multicast packet rate and loss information path from a source to a receiver (unicast router id
of the host running mstat). The results of this command will be available in the results buffer pool which can be displayed by
using the command “show mstat” on page 255. If a debug command is already in progress, a message is displayed and the new
request fails.
The <source> is the IP address of the remote multicast-capable source. The [receiver] is the IP address of the receiver. The
default value is the IP address of the system at which the command is issued. The [group] is a multicast address of the group to
be displayed. The default value is 224.2.0.1(the group used for the multicast backbone).
Note: The group and receiver IP addresses can be entered in any order.
▫ Default none
▫ Format mstat <source> [<group/receiver >] [<group/receiver>]
▫ Mode Privileged EXEC
13.1.7 mtrace
This command is used to find the IP Multicast path from a source to a receiver (unicast router ID of the host running mtrace). A
trace query is passed hop-by-hop along the reverse path from the receiver to the source, collecting hop addresses, packet
counts, and routing error conditions along the path, and then the response is returned to the requestor. The results of this
command are available in the results buffer pool which can be displayed by using the command “show mtrace” on page 255.
The <source> is the IP address of the remote multicast-capable source. The [receiver] is the IP address of the receiver. The
default value is the IP address of system at which the command is issued. The [group] is the multicast address of the group to
be displayed. The default value is 224.2.0.1(the group used for the multicast backbone). If a debug command is already in
execution, a message is displayed and the new request fails.
Note: The group and destination IP addresses can be entered in any order.
▫ Default none
▫ Format mtrace <sourceipaddr> [<group/destination>] [<group/destina-tion >]
▫ Mode Privileged EXEC
13.1.8 show ip mcast
This command displays the system-wide multicast information.
▫ Format show ip mcast
▫ Modes Privileged EXEC User EXEC