IAI America XSEL-QX - Manual (Page 234)

210
Part 4 Commands
z PAPR (Set push-motion approach distance, speed)
Command, declaration
Extension condition
(LD, A, O, AB, OB)
Input condition
(I/O, flag)
Command,
declaration
Operand 1 Operand 2
Output
(Output, flag)
Optional Optional PAPR Distance Speed CP
[Function] Set the operation to be performed when a PUSH command is executed.
Set the distance (push-motion approach distance) over which push-motion approach
operation (torque-limiting operation) will be performed in operand 1 (in mm), and set the
speed (push-motion approach speed) at which push-motion approach operation (torque-
limiting operation) will be performed in operand 2 (in mm/sec).
The push-motion approach distance specified in operand 1 may contain up to three decimal
places, while the speed specified in operand 2 cannot contain any decimal place.
[Example] PAPR 100 30
MOVP 10
PUSH 11
Set the push-motion approach distance in a PUSH
command to 100 mm and the push-motion approach
speed to 30 mm/sec.
(Note) When an OVRD command is used, the push-motion approach speed is clamped by the
minimum speed of 1 mm/sec.
(The minimum speed does not guarantee reliable push motion operation. If low-speed
push-motion approach is needed, confirm the operation on the actual machine by
considering the effects of mechanical characteristics, etc.)
Position origin
Push-motion approach distance
Start position of push-motion
approach operation
(torque-limiting operation)
Z
Y
X