Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 102)

Creating and Editing Ladder Program Files
6–11
Moving Between Files (Changing Files)
There are two ways to change program files:
Method 1 —
To enter a program into a different program file, press [F3], Exit, move the cursor to
the file you want to move and press
CONFIG OFFLINE
CONFIG
MONITOR
FILE
F8
. Using this method assumes that a
file and rung number have already been created. You do not have to enter the rung
number.
Method 2 — A program must exist
1. Locate the cursor on the file you wish to monitor and press
CONFIG OFFLINE
CONFIG
MONITOR
FILE
F8
.
2. At the prompt, type the file number separated by a comma and then the rung
number. For example:
3,0 .