Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 309)

Preface
Advanced Programming Software User Manual
16–16
Data Table File Displays
The following section provides a sample screen for each type of data table status file
display. The displays for timer, counter, control, floating point, and status data files
are pre-formatted, which means the option of changing radix is not available.
Note The memory space for the MicroLogix 1000 controllers is already allocated.
Therefore, their status file displays show the full range of elements.
Input Data Files (I:) and Output Data Files (O:)
The input and output data files display the elements that correspond to the specified
controller I/O configuration. In the display below, a fixed controller having 12
inputs is shown.
address 15 data 0 address 15 data 0
Press a key or enter value
I:0.0/0 =
REM PROG
no forces binary data decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FILE
F6
FORCE
MONITOR
F1
CHANGE
RADIX
I:0.0 0000 0000 0000
Bit Data File (B3:)
The display below shows the bit data file. In the display below, two elements are
shown; B3:0 and B3:1 with all bits reset to zero.
address 15 data 0 address 15 data 0
B3:0 0000 0000 0000 0000
B3:1 0000 0000 0000 0000
Press a function key
B3/0 =
REM PROG
no forces binary data decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FILE
F1
CHANGE
RADIX