Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 232)

Preface
Advanced Programming Software User Manual
11–38
Current Device 1784-KT (DH+ Bridged)
F1 Bridge Type DH+ to Channel 0 via 5/04 Passthru
Terminal Name
Terminal Address
77 (octal)
Baud Rate 57600
F5 Remote SLC Node Addr. 1 (decimal)
F6 SLC 5/04 DH+ Address 7 (octal)
F7 5/04 Channel 0 Link ID 2 (decimal)
IRQ 5
Board/Memory Address 001011
F8 Curr. Interchange Port 1
F9 Save to File
F9
Press a function key
SAVE TO
FILE
ESC exits/Alt-U aborts changes
ONLINE CONFIGURATION
F8
NEXT
PORT
F5
REMOTE
ADDRESS
F2
SELECT
DEVICE
F1
SELECT
BRIDGE
F6
SLC DH+
ADDRESS
F7
SLC 485
ADDRESS
Function Key Description
[F1] Select Bridge Type
Allows you to select the desired bridge type: DH+ to DH+ via
two 1785ĆKA, DH+ to DH485 via 1785 KA5 Gateway, PI
routing, or DH+ to Channel 0 via 5/04 passthru.
[F2] Select Device
Toggles between the selected device driver and the device
driver selection menu.
[F5] Remote SLC Node Address
Allows you to select a processor address as a node number. If
the remote network is DHĆ485, the valid range is 0-31
decimal. If the remote network is DH+, the valid range is 0–63
decimal. The default is 1.
[F6] SLC 5/04 DH+ Address
Allows you to select a processor address as a node number.
Valid range is 0–77 octal. The default is 1.
[F7] 5/04 Channel 0 Link ID
Allows you to select a processor address as a node number.
Valid range is 0–65,535 decimal. The default is 1.
[F8] Next Port
Allows you to select the port number where the interface card
is installed. Valid range is 1–8. The default is 1.
[F9] Save to File Saves the selected parameters to a user file.