Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 200)

Preface
Advanced Programming Software User Manual
11–6
1747-PIC Interface Converter
The 1747-PIC Interface Converter is the default interface module and supports
DH-485 communication. Note that the SLC 5/04 processor only supports DH-485
communication via channel 0 (RS-232). See the SLC 500 Modular Hardware Style
Installation and Operation Manual, Publication 1747-6.2 for connection
information.
F1 Port COM1
Current Device 1747-PIC (DH-485)
F3 Baud Rate 19200
F4 Terminal Address 0
F5 PROC Address 1
F6 MAX Node Address 31
F9 Save to File
F9
Press a function key
SAVE TO
FILE
F3
BAUD
RATE
F5 F6
PROC
ADDRESS
MAX
ADDRESS
F1
PORT
F2
SELECT
DEVICE
F4
TERM
ADDRESS
ESC exits/Alt-U aborts changes
ONLINE CONFIGURATION
Function Key Description
[F1] Port
Toggles between COM1 and COM2. This field indicates
where the processor is connected to your computer. The
default is COM1.
[F2] Select Device
Toggles between the selected interface card and the interface
card selection menu.
[F3] Baud Rate
Toggles between the communication rate of 1200, 2400, 9600,
and 19200. The default is 19200.
[F4] Terminal Address
Allows you to select a terminal address from 0–31 decimal.
The default is 0.
[F5] Processor Address
This is the default address of the processor the APS terminal
attempts to go online with. The default is 1.
[F6] Maximum Node Address
This is the maximum node address on the DHĆ485 network.
The default is 31.
[F9] Save to File
Allows you to save the established parameters to a user
configuration file that APS accesses to automatically setĆup
these parameters the next time you use the software.