Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 203)

Configuring Your Programming Device for Online Communication
11–9
Current Device 1784-KR (DH-485)
F3 Baud Rate 19200
F4 Terminal Address 0
F5 PROC Address 1
F6 MAX Node Address 31
F9 Save to File
F9
Press a function key
SAVE TO
FILE
F3
BAUD
RATE
F5 F6
PROC
ADDRESS
MAX
ADDRESS
F2
SELECT
DEVICE
F4
TERM
ADDRESS
ESC exits/Alt-U aborts changes
ONLINE CONFIGURATION
Note If you remove the 1784-KR card, the variable AB_OAKLAND must also be removed.
Failure to remove this variable may cause the software to lock up.
To remove the variable, at the DOS prompt:
Type: AB_OAKLAND=[ENTER] .
Do not place spaces on either side of the equal sign. This produces a different
variable.
Function Key Description
[F2] Select Device
Toggles between the selected interface card and the interface
card selection menu.
[F3] Baud Rate
Toggles between the communication rate of 1200, 2400, 9600,
and 19200. The default is 19200.
[F4] Terminal Address
Allows you to select a terminal address from 0–31 decimal.
The default is 0.
[F5] Processor Address
This is the default address of the processor the APS terminal
will attempt to go online with. The default is 1.
[F6] Maximum Node Address
This is the maximum node address of the KR on the DHĆ485
network. The default is 31.
[F9] Save to File
Allows you to save the established parameters to a user
configuration file that APS accesses to automatically set up
these parameters the next time you use the software.
For more information regarding the 1784-KR Interface Card, refer to Publication
1784-2.23.