Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 273)

Configuring Your Processor for Online Communication
13–23
To change the SLC 5/03 processor poll timeout value, do the following:
1. At the Program Directory display, press [F8] Monitor File , then [F7]
General Utility , then [F5] Channel Configuration .
2. Cursor to the System Mode Driver parameter and press [F10] Select Option
until “DF1 Half-Duplex Slave” is displayed.
3. Press [F4] CH0 System Configuration . Cursor to the poll timeout
parameter and press [F10] Select Option . Enter the new value and
press [ENTER] .
You can also change the edit resource/file owner timeout value at this time.
4. Press [F1] Accept Edits , then [ESC] , [ESC] , [ESC] and return to the
Program Directory display.
If you are using MSG instructions between SLC 5/03 processors, the MSG timeout
value shown in the control block may also need to be changed for reliable
slave-to-slave communication on the multi-drop network.