Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 226)

Preface
Advanced Programming Software User Manual
11–32
Interchange DH-485
The Interchange DH-485 option is available when using any of the SLC 500
processors with a 1747-PIC Interface Converter, the 1784-KTX interface card, or
with the 1784-PCMK card and a 1784-PCM4 cable.
Note You must edit the initialization file (cfg_kt.ini) found in the INTERCHANGE
directory in order to use the Interchange DH-485 option. To do this, use the
INTERCHANGE Device Configuration utility that was loaded during the APS
installation procedure. Refer to chapter 1 in this manual for configuration
information.
If the the INTERCHANGE driver is not loaded or the INTERCHANGE port selected
is not configured for use, all entries in the online configuration screen will display
asterisks (*), except SLC node addresses and the current INTERCHANGE port.
For cabling information, see the SLC 500 Modular Hardware Style Installation and
Operation Manual, Publication 1747-6.2.
Comm. Port COM1
Current Device DH-485
Baud Rate 57600
Terminal Address 0
F5 PROC Address 1
MAX Node Address 31
F8 Curr. Interchange Port 1
F9 Save to File
F9
Press a function key
SAVE TO
FILE
ESC exits/Alt-U aborts changes
ONLINE CONFIGURATION
F8
NEXT
PORT
F5
PROC
ADDRESS
F2
SELECT
DEVICE
Function Key Description
[F2] Select Device
Toggles between the selected device driver and the device
driver selection menu.
[F5] Processor Address
Allows you to select a processor address as a node number.
Valid range is 0–77 octal. The default is 1.
[F8] Next Port
Allows you to select the port number where the interface card
is installed. Valid range is 1–8. The default is 1.
[F9] Save to File Saves the selected parameters to a user file.