Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 222)

Preface
Advanced Programming Software User Manual
11–28
1784-KL (DH
+
Direct) Interface Card
Use the 1784-KL (DH
+
Direct) interface card to connect a T47 directly to an
SLC 5/04 processor on a DH
+
link for programming.
Current Device 1784-KL (DH+ Direct)
F3 Connection DIRECT
F4 Terminal DH
+
Address 0 (octal)
F5 SLC Node Address 1 (octal)
F9 Save to File
F9
Press a function key
SAVE T0
FILE
F5
SLC
ADDRESS
F3
CONNECT
TYPE
F2
SELECT
DEVICE
F4
TERM
ADDRESS
ESC exits/Alt-U aborts changes
ONLINE CONFIGURATION
Function Key Description
[F2] Select Device
Toggles between the selected interface card and the interface
card selection menu.
[F3] Connect Type
Toggles between Direct and MultiĆDrop. Direct means that the
terminal has a termination resistor (last device on the DH +
link). MultiĆDrop means that the terminal does not have a
termination resistor. The default is Direct.
[F4] Terminal Address
Allows selection of a terminal address as a node number.
Valid range is 0–77 octal. The default is 0.
[F5] SLC Address
Allows selection of a processor address as a node number.
Valid range is 0–77 octal. The default is 1.
[F9] Save to File Saves the selected parameters to the user file.