Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 357)

Preface
Advanced Programming Software User Manual
19–6
A period indicates that no force is installed. A 0 indicates that a force OFF is
installed. A 1 indicates that a force ON is installed. The status line indicates
whether the installed forces are enabled or disabled.
Note that menu functions OFF, ON, REMOVE, REMOVE ALL, ENABLE, and
DISABLE are available in this display. These allow you to:
•
move the cursor to any bit and enable a force ON or OFF (a 1 or 0 appears)
•
remove individual forces (the 0 or 1 changes to a period)
•
remove all forces (periods appear for all bits)
•
enable or disable the force function (does not apply to MicroLogix 1000
controllers.)
Use [F5] Specify Address to move the cursor to an address in either the
input or output force displays.
Data Monitor
The input data file can be accessed from the previous input force display. Press
CONFIG OFFLINE
CONFIG
DATA
MONITOR
F6
. The following display appears:
Press a key or enter value
I:0/0 =
REM RUN
forces ENABLED binary data decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FILE
F1
CHANGE
RADIX
F6
FORCE
MONITOR
address 15 data 0 address 15 data 0
I:0 0000 0000 0010
The display area shows input word I:0. Bit I:0/1, the address of the instruction you
forced, is set (1). The input data file reflects installed and enabled input forces.
You can return to the monitor input force display by pressing
CONFIG OFFLINE
CONFIG
FORCE
MONITOR
F6
.