Preface – Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 User Manual
Page 398
![background image](/manuals/580123/398/background.png)
Preface
Advanced Programmming Software User Manual
A–4
Display Message
Recommended Action
Description
CHANNEL CONFIGURATION MAY
CAUSE LOSS OF COMMUNICATIONS
Applies only if you are online. An
incompatibility exists between the 5/03
and the current online configuration
(APS).
Check your online configuration and
retry the function.
CHANNEL CONFIGURATION NOT
AVAILABLE FOR SELECTED
PROCESSOR
A processor other than an SLC 5/03 or
SLC 5/04 is selected.
Verify that an SLC 5/03 or SLC 5/04
processor is selected. Retry the function.
CHANNEL CONFIGURATION
MODIFIED, ACCEPT OR UNDO
CHANGES
The [ESC] or [ALT-U]
key was pressed
after a change was selected.
Informational message. No action
necessary.
CHANNEL CONFIGURATION MAY
CAUSE LOSS OF COMMUNICATIONS
Online only - An incompatibility between
the SLC 5/03 or SLC 5/04 and the
current online (APS) configuration exists.
Verify that the selected online
configuration is compatible with an
SLC 5/03. Retry the function.
COMMAND CANNOT BE EXECUTED
This message could mean 1) you are
not the program owner; or 2) the file is in
use by another device.
Determine why another node has explicit
access.
COMMENT DATA LOST
The text storage capacity of a rung,
address, or instruction comment has
been exceeded.
Install a memory module, change mode,
or install forces.
CONDITION CANNOT BE GENERATED This message indicates either 1) no
memory module exists; 2) the processor
is in fault mode; or 3) no forces are
installed.
Informational message. No action
necessary.
CONFIRMATION TIMEOUT - LOSS OF
COMMUNICATIONS
The communication interface module did
not return the status of the message
sent within 5 seconds.
Check the connection to the DH
+
network and retry the function.
CONVERSION SUCCESSFULĆBYTES
CONVERTED
An archive file was successfully
converted into a hex file.
Send the hex file to a prom programmer.
CREATION OF XREF DB ENTRY
FAILED
While attempting to create the cross
reference database during create
reports, a database call generated an
error.
Contact your RSI representative.
CUT/COPY/PASTE FUNCTION NOT
AVAILABLE DURING ONLINE EDITING
An attempt to perform a cut/copy/paste
was made during a runtime online edit.
Change to the program online edit mode
and try the cut/copy/paste function
again.
DATA FILES CAN ONLY BE
PROTECTED FOR 5/03 PROCESSOR
TYPES
An attempt to modify program protection
for a non 5/03 processor occurred.
Change the processor to an SLC 5/03
and retry the function.
DATA VALUE CANNOT BE MODIFIED
DUE TO FILE PROTECTION
An attempt to alter an element within a
protected data table was made from the
multiĆpoint list.
Informational message. No action
necessary.