Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 16)

Installing the Software
1–9
[APS]
DEVICEhigh=C:\DOS\ANSI.SYS
FILES=40
BUFFERS=40
Installing the Software or Software Updates
Before you actually install the software, complete the prepaid postage Software
Updates registration card and return it to Rockwell Software Incorporated. This is
very important, since it confirms your registration.
Inside the software envelope you will find the APS software, Catalog Number
9323-PA2E, on 3.5 inch high-density disks. If you require 5.25 inch or 3.5 inch
low-density disks and are a registered user, contact the media exchange service at
1-800-289-2279. Have your software serial number available when you call.
We assume that you have installed DOS in your computer. If you have not, do this
now, following the instructions supplied with your computer.
Checking Available Memory
To determine if your computer has enough memory for the software, at the DOS
prompt type:
CHKDSK , then press [ENTER] . The screen displays the memory
configuration of your computer. Check the last line of the display XXXXXX bytes
free . See page 1–2 for memory requirements.
Updating the System Files
To update your system files, follow the instructions supplied with your computer.
You must re-boot the system to initialize any changes you make.
AUTOEXEC.BAT File
Make sure your AUTOEXEC.BAT file contains this statement:
C:\DOS\SHARE.EXE