Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 375)

Preface
Advanced Programming Software User Manual
21–2
Program Transfer Overview
For the examples in this section, the DH-485 network is configured as follows:
Node Address Network Device
0 APS Terminal
1 SLC 500Ć20 Processor
2 SLC 5/02 Processor
3 IBMĆAT APS Terminal
4 HandĆHeld Terminal
Allen–Bradley 1784–T45, T47
or Compatible Laptop SLC 500
Hand-Held Terminal
SLC 500 20 Point
Fixed I/O Controller
IBM-PC, XT, or compatible
with 1784-KR, DH-485 PC Interface
SLC 500 5/02
Modular I/O Controller
1747-AIC Isolated
1747-PIC
Interface Converter
Link Coupler
1747-AIC Isolated
Link Coupler
1747-AIC Isolated
Link Coupler
1747-C10
Cable
24 VDC Power Supply
1747ĆNP1 or 1747ĆNP2
Note Program transfers are not supported if the current online configuration is for a
direct DH
+
connection or if the communication driver is an INTERCHANGE driver.